LESSON PLAN
Kevin Scheib (Wood Shop and Plastics Technology) weekly lesson plans (11/7/2011 to 11/11/2011)
Monday 11/7

Pd. 1,4,7 Basic Wood: Students will continue the sanding of the project pieces and cutting the angle on the middle brace piece.
Pd. 5 Advanced Cabinetmaking: I will be giving a demonstration on using the Dado blades on the tale saw to cut Dado joints in two students project pieces.
Pd. 2,3 Plastics Technology: I will be giving the demonstration on getting The Mug project started. We will be cutting a piece of clear acrylic for the bottom of the mug. I will be give demonstration on how to glue it in position.
Tuesday 11/8

Pd. 1,4,7 Basic Wood: We will start to plan lumber down to make the top of the benches. We will be gluing the boards together to achieve the proper width.
Pd. 5 Advanced Cabinetmaking: Students will be working on projects. I will be giving a demonstration on assembling the lower cabinet of a gun cabinet.
Pd. 2,3 Plastics Technology: Students will be working on glue it in position if they did not get to it on Monday. I will be giving a demonstration on how to sand the edges of the bottom down to the proper side and how to use the hand sanders.
WENDNESDAY 11/9

Pd. 1,4,7 Basic Wood: I will be giving a demonstration on gluing the boards together for the proper width. We will then start to glue. All students will be helping with this so they have a full understanding of the process.
Pd. 5 Advanced Cabinetmaking: I will be giving a demonstration on using the Dove tail cutters. We will be using them on a large blanket chest.
Pd. 2,3 Plastics Technology: Students will be sanding the bottom to proper size. I will give demonstration on buffing it to finish the bottom. Students will be receiving the acrylic rod for the handle.
Thursday 11/10

Pd. 1,4,7 Basic Wood: We will be cutting boards to a rough measurement and then each student will be planning their own board done to the proper thickness of ¾”. They will then run the board through the jointer and then the table saw to achieve the proper width. They will then cut to the proper length and make sure it is square.
Pd. 5 Advanced Cabinetmaking: Students will continue to work on projects

Pd. 2,3 Plastics Technology: Students will be finishing the sanding and the buffing of the bottom of the mug.

Friday 11/11 No School for Students Act 80 Day In Service

Pd. 1,4,7 Basic Wood:

Pd. 5 Advanced Cabinetmaking:

Pd. 2,3 Plastics Technology:

FOR ALL PERIODS:
PA. Standards (Science & Technology); 2.1, 2.2, 2.3, 3.2, 3.4, 3.6
Objectives; Wood shop-To have students fully understand process of how to use different types of measuring devices and how to measure accurately. Students will also learn safe and acceptable procedure for the shop.
Plastics- To have students fully understand process of how to use different types of measuring devices and how to measure accurately. Students will also learn safe and acceptable procedure for the shop.
Assessments; Will be done by Question and Answers and Quiz.