Kevin Scheib (Wood Shop and Plastics Technology) weekly lesson plans (1-2-2012 to 1-4-2012) Monday 12/31/12 Pd. 1,7 Plastics: Students will be doing their writing prompt on Why Recycle Plastic. Pd. 2,3,6 Basic Wood : Students will be working on the clock project. They will be routering out the area on the dial board for the clock movement. Pd. 5 Advanced Cabinetmaking: Students will be working on individual projects. Some students are assembling and some students will be starting to stain projects. I will continue to demonstrate new procedures as they are needed. Tuesday 1/1 I Will Be Out Of School This Day Pd. 1,7 Plastics: Students will have work to do. Pd. 2,3,6 Basic Wood: Students will have work to do. Pd. 5 Advanced Cabinetmaking: Students will have work to do. WEDNESDAY 1/2 Pd. 1,7 Plastics: Students in the 1st pd. will continue with the chess set project they will be putting on the last coats of latex on chess pieces. Pd. 2,3,6 Basic Wood: Students will continue to work on the clock parts. I will give a demonstration on how to router edges of parts of the clock. Students will start to sand all parts and prepare to assemble the clock. Pd. 5 Advanced Cabinetmaking: Students will continue to work on individual projects and I will assist students when assistance is needed. Thursday 1/3 MID TERMS START TODAY Pd. 1,7 Plastics: 1st pd will start to remove the chess pieces from the molds. I will give a refresher demo on removing the chess pieces from molds. Pd. 2,3,6 Basic Wood: Students will continue with sanding and rotering. Pd. 5 Advanced Cabinetmaking: Students will be working on individual projects. I will be going around and checking on progress. 7th Friday 1/4 MIDTERMS Pd. 1,7 Plastics: 1st will continue with removal of chess pieces from molds. 7th period will continue with coin case project. 7th pd will be working on the coin case project. I will assign six students to do the dipping process. Pd. 2,3,6 Basic Wood: We will start to assemble the clock project. Students will be using the air gun to assemble the clock. Strict safety procedures must be followed. Pd. 5 Advanced Cabinetmaking: Students will continue to work on individual projects. FOR ALL PERIODS: PA. Standards (Science & Technology); 2.1, 2.2, 2.3, 3.2, 3.4, 3.6 Objectives; Wood shop-To have students fully understand process of how to use different types of measuring devices and how to measure accurately. Students will also learn safe and acceptable procedure for the shop. Plastics- To have students fully understand process of how to use different types of measuring devices and how to measure accurately. Students will also learn safe and acceptable procedure for the shop. Assessments; Will be done by Question and Answers and Quiz.