LESSON PLAN Kevin Scheib (Wood Shop and Plastics Technology) weekly lesson plans (1-14-2012 to 1-18-2012) Monday 1/14/12 Mid Term Day Pd. 1,7 Plastics: Pd. 2,3,6 Basic Wood : Pd. 5 Advanced Cabinetmaking: Tuesday 1/15 Mid Term Day Will Follow Two Hour Delay Schedule Pd. 1,7 Plastics: Students in 1st. will put last coat of material on chess pieces. 7th pd will coat picture with thick coating material. This is 4.5” by 4.5” block of wood that will become a picture frame. Pd. 2,3,6 Basic Wood: Students will be Sanding all project pieces and using the rotor table on certain Pieces. I will set up the table saw with the dado blade so we can cut the dados in the side pieces. Pd. 5 Advanced Cabinetmaking: Students will be working and I will be going around and helping as needed. WEDNESDAY 1/16 Pd. 1,7 Plastics: Pd. 2,3,6 Basic Wood: Students will continue to work on the clock parts. I will give a demonstration on how to router edges of parts of the clock. Students will start to sand all parts and prepare to assemble the clock. Pd. 5 Advanced Cabinetmaking: Students will continue to work on individual projects and I will assist students when assistance is needed. Thursday 1/17 Pd. 1,7 Plastics: 1st pd. will be removing the chess pieces from molds. They must take their time in order not to damage the molds. Seventh pd. will continue with the dip project. Everyone must do at least one dip project. Pd. 2,3,6 Basic Wood: We will continue with the dado cuts and Sanding. All router work should be done. I will stress the importance of hand sanding all end grain edges. Pd. 5 Advanced Cabinetmaking: Students will be working on individual projects. I will be going around and checking on progress. 7th Friday 1/18 MIDTERMS Pd. 1,7 Plastics: 1st will continue with removal of chess pieces from molds. 7th period will continue with coin case project. 7th pd will be working on the coin case project. I will assign six students to do the dipping process. Pd. 2,3,6 Basic Wood: We will start to assemble the clock project. Students will be using the air gun to assemble the clock. Strict safety procedures must be followed. Pd. 5 Advanced Cabinetmaking: Students will continue to work on individual projects. FOR ALL PERIODS: PA. Standards (Science & Technology); 2.1, 2.2, 2.3, 3.2, 3.4, 3.6 Objectives; Wood shop-To have students fully understand process of how to use different types of measuring devices and how to measure accurately. Students will also learn safe and acceptable procedure for the shop. Plastics- To have students fully understand process of how to use different types of measuring devices and how to measure accurately. Students will also learn safe and acceptable procedure for the shop. Assessments; Will be done by Question and Answers and Quiz.